Underfloor Heating Installers in Perth – Free Quotes from Specialist Installers
Looking for underfloor heating installers in Perth? We can pass your details to installers covering Perth who design and fit wet and electric underfloor heating, from a single bathroom mat to a whole ground floor. Each installer will work out how much heat each room needs, suggest a system that suits your floor build-up and explain how it will be controlled.
Is Underfloor Heating Right for Your Perth Home?
- You're building an extension and the floor hasn't been laid yet
- Radiators would get in the way of kitchen units or glazing
- Tiled floors feel cold underfoot in the morning
- You want the whole room evenly warm rather than hot near a radiator
- You're planning a heat pump now or in the future
- A bathroom refit is a chance to add a heated floor
Systems Our Perth Installers Fit
- Wet system in screed – the most efficient choice for extensions and new floors
- Low-profile wet system – for existing floors where height is tight
- Wet system between joists – for upper floors and suspended timber floors
- Electric mat – quick to fit under tiles in bathrooms and small kitchens
- Electric foil or cable – under laminate, wood or vinyl floors
- Controls – a thermostat in each room or zone, including smart options
Perth Underfloor Heating Costs
The cost of underfloor heating in Perth depends on the floor area, wet or electric, the existing floor and whether screed and finishes are part of the job. As a guide:
| Project | Typical cost in Perth (inc. VAT) |
|---|---|
| Electric underfloor heating in a bathroom | £1,000 – £2,000 |
| Wet system in a 20–40m² extension | £2,500 – £4,500 |
| Wet system across a ground floor | £4,500 – £7,500+ |
Electric mats are cheaper up front but dearer to run over large areas, so for anything bigger than a bathroom, a wet system usually works out better value over time.
Building Regulations and Underfloor Heating in Perth
You won't need planning permission for underfloor heating in an existing room. An extension will need building regulations approval, including the floor insulation beneath the heating, and electric systems on a new circuit should be fitted by a registered electrician. For planning and building control guidance in Perth, visit the Perth and Kinross Council website.
Areas Covered Near Perth
Available heating specialists also work in places close to Perth such as Benbecula, Brae, Castlebay, Lerwick, Lochboisdale, Scalloway, Stornoway, and across the wider Perth and Kinross area.
Compare Underfloor Heating Prices in Perth
Tell us the rooms and floor area you'd like heated and what the floor is made of, and up to four specialist installers can contact you with prices. It's free and there's no obligation.
Before pipe or mats go down, the installer should check insulation, available floor height, heat loss and the final floor finish. Wet systems need manifold and mixing arrangements where appropriate; electric mats need suitable electrical protection and testing.
Common questions from homeowners
How much does underfloor heating cost in Perth?
Underfloor heating in Perth typically costs between £1,000 and £7,500. A single bathroom with an electric mat is the cheapest type of job, and a fully screeded wet system under an entire ground floor is the most expensive.
How long does underfloor heating take to install?
An electric mat in a bathroom can be laid in a day. A wet system in an extension takes one to five days to install, but screed then needs several weeks to dry before floor finishes go down.
Does underfloor heating raise the floor level?
Low-profile systems and electric mats add only a few millimetres to a couple of centimetres. Screeded systems need more depth, which is easiest to allow for in a new extension.
Can I have underfloor heating and radiators together?
Yes. Many homes run underfloor heating downstairs and radiators upstairs from the same boiler, with a mixing valve keeping the underfloor circuit at a lower temperature.